掺钪AlN材料特性及HBAR器件性能研究
作者:
作者单位:

作者简介:

朱宇波(1997-),男,上海市人,硕士生,主要从事体声波谐振器材料和器件的研究

通讯作者:

基金项目:

上海市自然科学基金资助项目(21ZR1474500);上海市集成电路科技支撑专项基金资助项目(20DZ1100603)

伦理声明:



Study on the Scandium-Doped AlN Films and HBAR Devices
Author:
Ethical statement:

Affiliation:

Funding:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
    摘要:

    该文基于掺钪AlN薄膜制备了高次谐波体声波谐振器(HBAR),研究了钪(Sc)掺杂浓度对AlN压电薄膜材料特性及器件性能的影响。研究表明,当掺入Sc的摩尔分数从0增加到25%时,压电应力系数e33增加、刚度 下降,导致Al1-xScxN压电薄膜的机电耦合系数 从5.6%提升至15.8%,从而使HBAR器件的有效机电耦合系数 提升了3倍。同时,当Sc掺杂摩尔分数达25%时,Al1-xScxN(x为Sc掺杂摩尔分数)压电薄膜的声速下降13%,声学损耗提高,导致HBAR器件的谐振频率和品质因数降低。

    Abstract:

    In this paper, the high-overtone bulk acoustic resonators (HBAR) were fabricated based on the scandium-doped AlN thin films, and the effect of scandium(Sc) doping concentration on the material properties of AlN piezoelectric thin films as well as the performance of devices were investigated. The results showed that, as the Sc mole fraction increased from 0 to 25%, the piezoelectric stress coefficient e33 increased and the stiffness constant decreased, resulting in an increase of the electromechanical coupling coefficient of Al1-xScxN piezoelectric film from 5.6% to 15.8%, thereby increasing the effective electromechanical coupling coefficient of HBAR device by a factor of three. At the same time, when the Sc mole fraction was up to 25%, the sound velocity of the Al1-xScxN film piezoelectric film was reduced by 13%, and the acoustic loss was increased, resulting in a decrease of the resonant frequency and quality factor Q of the HBAR device.

    参考文献
    相似文献
    引证文献
引用本文

朱宇波,母志强,陈玲丽,朱雷,李卫民,俞文杰.掺钪AlN材料特性及HBAR器件性能研究[J].压电与声光,2022,44(2):299-303. ZHU Yubo, MU Zhiqiang, CHEN Lingli, ZHU Lei, LI Weimin, YU Wenjie. Study on the Scandium-Doped AlN Films and HBAR Devices[J]. PIEZOELECTRICS AND ACOUSTOOPTICS

复制
分享
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
历史
  • 收稿日期:
  • 最后修改日期:
  • 录用日期:
  • 在线发布日期: 2022-05-11
  • 出版日期: